+++ “Inserts have to be rigidly coupled with the cutter body!” +++
General statement in milling technology, or did you have other alternatives?
SPINWORX® – the new system of milling cutters with round inserts puts into question, which has been an effective operation for decades.: the insert has to be rigidly coupled to the cutter body. In case it would be loose in its insert-seat, it would break, earlier or later!
Not at all with SPINWORX® – the insert rotates and thus, manual re-locating becomes redundant. Through the rotating insert in the seat of the milling cutter, notch wear is not occuring any more; so you get a 100%-utilization of the existing cutting edge and you are able to use maximum capacity without any loss.
SPINWORX® sets new standards!